Quadro 240 board master-in, double-out checkouts

Checkout tables for master-in, double-out darts games with the Quadro 240 board

Introduction

This part of the darts > Tables > HTML project provides checkout tables for darts games with the Quadro 240 board played in master-in, double-out mode. These tables are valid for games where the first (in) dart must land on a double or a triple, and the last (out) dart must land on a double.

In double-out games with the Quadro 240 board, the last dart can score between 2 and 50 points. The last two darts can reach 130 points, and 210 points can be scored with the last three. After a double or triple has been thrown, the extensive any-in, double-out checkout tables apply to these scores.

As for master-in, double-out checkouts, the following can be observed. Darts games commonly require players to score x01 points, where x is an integer. The following table shows the required number of darts to reach such scores in Quadro 240 board master-in, double-out games. In addition, the corresponding number of possible checkouts is shown.

Score Darts Checkouts
101 2 1
201 4 1,428
301 5 1,084
401 6 172
501 7 1
601 9 763,923
701 10 85,068
801 11 2,148
901 12 1
1001 1446,245,501

The most exciting games will be those with relatively few possible checkouts. Checkout tables for these scores are given below. Additional tables can be generated using the darts toolbox of the darts project.

101

Score12#
101**1
T17D251

This table was generated using the command:

darts checkouts -b quadro -i master -o html 101 101

501

Score1234567#
501*******1
T17Q20Q20Q20Q20Q20D251

This table was generated using the command:

darts checkouts -b quadro -i master -o html 501 501

901

Score123456789101112#
901************1
T17Q20Q20Q20Q20Q20Q20Q20Q20Q20Q20D251

This table was generated using the command:

darts checkouts -b quadro -i master -o html 901 901

License

Copyright © 2023 Maurits Silvis

This source code package is subject to the terms and conditions defined in the GNU General Public License v3.0 or later.